DVM - Design Verification Module

NoSimulation

The NoSimulation Test Objective is used to tell the program not to launch a simulation for a particular test. This is most commonly used for tests which either gather information from previous reports for plotting, or to prepare the schematic for a follow on test. NoSimulation is used in the built-in efficiency testplan to generate the efficiency curves from previous reports. It is also used in the DVM Tutorial where the ExtractCurve() function is first introduced.

See Also:

• DVM Tutorial: 6.6.4 Using the ExtractCurve() Function
• DVM Tutorial: 6.6.5 Using the CreateXYScalarPlot() Function
• DVM Tutorial: 8.1 Adding Power Losses to a Testplan
• DVM Tutorial: 8.2 Measuring Control Loop Parameters
• ExtractCurve()
• CreateXYScalarPlot()

© 2015 simplistechnologies.com | All Rights Reserved